Re: 使用 MPLAB ICD2 LE 出現 Invalid target device id為什麼?
|
||||
---|---|---|---|---|
新會員
|
我會再次試驗,謝謝---
發表於: 2007/7/25 4:34
|
|||
|
Re: 使用 MPLAB ICD2 LE 出現 Invalid target device id為什麼?
|
||||
---|---|---|---|---|
新會員
|
我會再試一試---
謝謝你不吝指導!
發表於: 2007/7/24 21:42
|
|||
|
Re: 使用 MPLAB ICD2 LE 出現 Invalid target device id為什麼?
|
||||
---|---|---|---|---|
資深會員
|
檢查一下那5條燒錄線,千萬別接錯了...
LE本身不提供電源,所以發展版必須要接9V電源.
發表於: 2007/7/24 8:32
|
|||
|
使用 MPLAB ICD2 LE 出現 Invalid target device id為什麼?
|
||||
---|---|---|---|---|
新會員
|
這幾天我第一次開始使用 MPLAB ICD2 LE 時
我選擇device 是p30f4011,在debugger->connet結果產生了 ICDWarn0020: Invalid target device id (expected=0x101, read=0x0) ... Reading ICD Product ID Running ICD Self Test ... Failed Self Test. See ICD2 Settings (status tab) for details. MPLAB ICD 2 Ready 我的 MPLAB ICD2 LE 出了什麽問題,7/11所送的電路板16-BIT 28-PIN STARTER DEVELOPMENT BOARD 是否要加9伏的直流電 謝謝各位先進前輩指導,希望有人能告知或是microchip專業人員能回答 Lui Ming-Ching
發表於: 2007/7/23 19:38
|
|||
|