Re: 請問該如何解決此警訊"ICDWarn0020"
|
||||
---|---|---|---|---|
初級會員
|
謝謝2位大哥意見,我把RB3/PGM Pull down 後就可以嚕。
發表於: 2009/3/31 16:39
|
|||
|
Re: 請問該如何解決此警訊"ICDWarn0020"
|
||||
---|---|---|---|---|
高級會員
|
看你是用debugger or programmer mode
進入settings/power檢查是否有外接或ICD2電源即可
發表於: 2009/3/31 16:14
|
|||
|
Re: 請問該如何解決此警訊"ICDWarn0020"
|
||||
---|---|---|---|---|
版主
|
利用右上角的搜尋區塊輸入 "Invalid target" 就有一堆結果。還有使用PIC16F883 燒錄時,Low Voltage Programming 那隻腳不要空在那裡。
http://ww1.microchip.com/downloads/en/DeviceDoc/80302D.pdf PIC16F882/883/884/886/887 Silicon/Data Sheet Errata 1. Module: Low-Voltage In-Circuit Serial Programming™ If LVP (Low-Voltage Programming) mode is enabled, programming the device using the VPP pin while holding high or toggling the port pin RB3/PGM during Program mode could disrupt the programming sequence. Work around Pull down pin RB3/PGM using external circuitry during programming of the device.
發表於: 2009/3/31 16:07
|
|||
|