謝了各位!

請問一下C18函式庫有包含三角函數與積分/微分的函式庫嗎?
那能找到資料?
謝謝大家.

請參考http://www.htsoft.com/downloads/updates.php
有免費的試用版可參考但有時間限制.
>>想辦法讓老闆花錢吧!

YES! 找到解決方式了.
要將指標強制切到bank1或其他bank.做法如下:

bank1 char RXRST[77]; //會將之規劃放在bank1
char tow[10][2];

謝謝!

請問 HI-TECH PICC矩陣空間會自行規劃放到RAM BANK的位置嗎?
MCU:16F877A
宣告 矩陣空間:
char RXRST[77];
char tow[10][2];

但compiler完後發生如下的錯誤,我懷疑是否compiler完後
沒有將矩陣空間會自行規劃放到RAM BANK的位置?

Error[000] : Can't find 0x68 words for psect rbss_0 in segment BANK0
Error[000] : Can't find 0x3 words for psect temp in segment COMBANK

謝謝!

HO! God!
謝謝你的回覆,我已經跟Grant緊急下order了.

求救:發生ICD0083錯誤訊息 檢查結果 如下:
使用:PIC16F684 內部RC
以下是依照ICD0083錯誤訊息 檢查結果 :
ICD0083:
1.Target processor has not been programmed with a debug executive (i.e., MPLAB ICD 2 was selected as a programmer, not a debugger.)
檢查結果 :設定在Debug模式

2.Target application is not powered.
檢查結果 :有電源+5vdc

3.Target application does not have an oscillator.
檢查結果 :
Configuration bit setting:Interner RC NO CLOCK

4. The BOD bit is enabled during low voltage usage.

檢查結果 :Configuration bit setting :BOD and SBOREN disable

5.Configuration bit setting for oscillator (Configure>Configuration Bits) are incorrect for target oscillator.

檢查結果 :OSC使用Interner RC NO CLOCK
Watchdog timer:OFF
Power UP timer: OFF
Master clear enable: External
Code potecte:OFF
Data EE read protect:OFF
Brown out detector:BOD and SBOREN disable
Internal External switch over mode:Disable
Monitor clock fail-safe:Disable

PS:我有檢查ICD2到IC的接腳是正確的,但是MCLR準位一直是LOW,若將ICD2拔除MCLR又回復到HIGH.

謝謝 !