PIC12F675的datasheet 上面寫Wide operating voltage range - 2.0V to 5.5V,但是利用PICKit2及IDEv8.02要進入programmer mode時,出現以下訊息 "PK2Error0023: Target Vdd measured at 3.33V which is outside the operational range of this device ( 4.50V - 5.50V)"。 因為板子部份不希望加另外的硬體將5v轉3v,所以想問各位大大,是否有其他方法去設定,如IDE。讓PIC12F675也可在datasheet規定的3v工作電壓運作。感謝