:::
Browsing this Thread:
1 Anonymous Users
|
Re: [Problem of programming with MPLAB PM3] DsPICDEM development board 1.1
|
||||
|---|---|---|---|---|
|
版主
 
|
Please refer to the dsPIC30F Programming Specification as folloeing web linker:
http://ww1.microchip.com/downloads/en/DeviceDoc/70102G.pdf CLK & Data 必須連接到 PGC & PGD Vpp 連到 MCLR VDD 必須連接所有的 Vdd 及 AVdd GND 必須連接所有的 Vss 及 AVss
發表於: 2006/11/15 17:17
|
|||
|
||||
|
[Problem of programming with MPLAB PM3] DsPICDEM development board 1.1
|
||||
|---|---|---|---|---|
|
新會員
 
|
版主老师好!
我们现在碰到的问题是: 已经知道ICSP上使用CLK,DATA,VPP,VDD,GND五根线来烧录程序.但是不知道如何连接. ICSP上CLK连Pic30F6014上RB1还是PGC/EMUC (ICD2烧录时使用的时钟输入端口)?.剩下的四条线应该怎么连接呢? 谢谢 
發表於: 2006/11/14 20:27
|
|||
|
||||
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.
