Hi 各位先進: 我使用PIC16F690 PIN4(RA3/MCLR/VPP) 當成按鍵輸入腳,並把按鍵另外一腳接到地(VSS) 也已經LAY好板子。 最近,重新檢視PIC 時才發現Data Sheet 第229頁的一段說明: Voltage spikes below VSS at the MCLR pin, inducing currents greater than 80 mA, may cause latch-up. Thus, a series resistor of 50-100 Ω should be used when applying a “low” level to the MCLR pin, rather than pulling this pin directly to VSS. 我的MCLR 腳並沒有接到外部、我的板子是乎沒有空間去增加這個電阻 是必需要的嗎?