Browsing this Thread:
1 Anonymous Users
|
使用ccs c 編輯12f675時,燒錄不會自動帶入fuse設定
|
|
新會員
Joined
: 2010/1/29 11:19 最後登入時間
: 2010/6/1 16:49
Group:
註冊會員
Level : 1 HP : 0 / 0 MP : 0 / 0 EXP : 0
|
小弟是用wellon的vp-280燒錄器,應該是會自動讀取hex的code帶入fuse的配置,可是我寫完後,每次燒錄都要重新手動設定燒錄的配置,不知道小弟的配置檔有什麼問題,以下是程式部份,請各位高手指點,謝謝 led.h的部份 ----------------------------------------------------------- #include <12F675.h> #device adc=10 #FUSES WDT //No Watch Dog Timer #FUSES INTRC_IO //Internal RC Osc, no CLKOUT #FUSES CPD //No EE protection #FUSES PROTECT //Code not protected from reading #FUSES MCLR //Master Clear pin enabled #FUSES NOPUT //No Power Up Timer #FUSES BROWNOUT #FUSES RESERVED #FUSES BANDGAP_HIGH #use delay(clock=4000000) -----------------------------------------------------------
led.c部份 ------------------------------------------------------------ #include "LED.h"
void main() { setup_adc_ports(sAN1|VSS_VDD); setup_adc(ADC_CLOCK_INTERNAL); setup_timer_0(RTCC_INTERNAL|RTCC_DIV_1); setup_timer_1(T1_DISABLED); setup_comparator(NC_NC); setup_vref(FALSE);
while() ..... } -----------------------------------------------------------
發表於: 2010/1/29 11:37
|
|
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.