:::
Browsing this Thread:
1 Anonymous Users
|
Re: ICD3 與 PIC24FJ256GA106 連接問題
|
||||
|---|---|---|---|---|
|
版主
 
|
”Target Device ID does not match expected Devicd ID”
是不是 MPLAB IDE 下的 Device Select 選錯元件了，請確定一下 MPLAB IDE 設定的元件與 Target Board 一樣。
發表於: 2009/6/5 17:01
|
|||
|
||||
|
Re: ICD3 與 PIC24FJ256GA106 連接問題
|
||||
|---|---|---|---|---|
|
新會員
 
|
1) 使用ICD3 test interface board 自我測試ok 如下
Test interface clock write succeeded. Test interface data write succeeded. Test interface clock read succeeded. Test interface data read succeeded. Test interface LVP succeeded. Test interface MCLR succeeded. Interface test completed successfully. Your ICD 3 is functioning properly. 2) 當使用ICD3連接至ICD2 RJ11小板子(ACI164110 02-01885-R1)再接至DUT時 出現下錯誤訊號 Target Device ID does not match expected Devicd ID 所以不知是哪裡的問題? 此時ICD3 燈號狀態 Power 綠 Active 藍 Status 綠
發表於: 2009/6/4 16:08
|
|||
|
||||
|
Re: ICD3 與 PIC24FJ256GA106 連接問題
|
||||
|---|---|---|---|---|
|
版主
|
參照：
發表於: 2009/6/4 13:19
|
|||
|
||||
|
ICD3 與 PIC24FJ256GA106 連接問題
|
||||
|---|---|---|---|---|
|
新會員
|
請問各位先進
欲把程式藉由ICD3寫進此MCU中,連接方式如下不知有無問題 1) a. PC 透過usb連接至ICD3, b. ICD3透過cable連接至 ICD3 test interface board, c. test interface board透過自製cable連接至DUT (只使用#MCLR,ICSPDAT,ICSPCLK,GND 4pin) 2) ICD3 test interface board 比 ICD2 test interface board 多顆IC,請問差異性?皆可搭配ICD3使用嗎? 因為第一次使用,所以問題不少,謝謝~
發表於: 2009/6/3 9:31
|
|||
|
||||
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.
