Re: 想請教VDD電壓 , 跟Hi準位電壓差
|
||||
---|---|---|---|---|
資深會員
|
重點是中間 灰色地帶
如果是單純 I/O 對接 , 應該問題不大 雖沒有詳細電路 , 但 I/O 輸出應該是 N-P ch MOSFET , 如無外加電路干擾 ( 電流太大 , 壓降增加 ) 其輸出準位 , 應該也可符合 Schmitt level 但這都需要你自己 測試 判斷 決定 , 你老板不可能來罵我吧 !
發表於: 2009/8/23 2:43
|
|||
|
Re: 想請教VDD電壓 , 跟Hi準位電壓差
|
||||
---|---|---|---|---|
版主
|
這是基本觀念的問題,在輸入部分需了解何為 Vil & Vih,輸出的話就須了解 Vol & Voh。此外擬也要知道什麼是 TTL Level, CMOS Level and Schmitt Trigger Level 的相關電壓定義。
以下圖為例輸入電壓 Vil 就有 TTL level 及 Schmitt level 這兩種腳位對 Low 的判定都不一樣。 Vih 輸入在一般 I/O 時,超過 2.0V 為 Hi (TTL Level),如該腳為 Schmitt Trigger input 就須在 0.8 x 5V = 4.0V 以上才算是 High Level。 所以說當用 CMOS 輸出店位去推TTL Level 的輸入時,可以嗎? 答案是可以的。 如果用TTL Level 去推 CMOS Level 的輸入呢? 答案是不一定可以,就算是可行也是很危險的設計。中間的差異自己想一下。 Attach file: (0.00 KB)
發表於: 2009/8/21 17:53
|
|||
|
想請教VDD電壓 , 跟Hi準位電壓差
|
||||
---|---|---|---|---|
新會員
|
我司使用 PIC16F676
觀察舊有電路 有了這個疑問 想請教一下專家能不能幫我回答
發表於: 2009/8/21 16:30
|
|||
|