:::
Browsing this Thread:
1 Anonymous Users
|
Re: variable addressing on c18
|
||||
|---|---|---|---|---|
|
版主
 
|
看起來是變數位址重複使用的問題，一般由 Linker 自行安排的變數位址是從 0x80 開始。你可以將你的 UDATA 指到 access bank (NEAR) 以解決Variable Overlay 的問題。
發表於: 2005/11/18 11:13
|
|||
|
||||
|
variable addressing on c18
|
||||
|---|---|---|---|---|
|
新會員
 
|
Hi,
I wanna define a structure from the address 0x0080 using c18. These are my codes: #pragma udata MeasureData=0x0080 struct { unsigned int Ia; unsigned int Ib; unsigned int Ic; unsigned int Ig; unsigned int Inm; unsigned int In; unsigned int IIt; }MeasureData; But the MPLAB outputs a error when BUILD ALL Error - section 'MeasureData' type is non-overlay and absolute but occurs in more than one input file. Please give me a hand, thanks a lot.
發表於: 2005/11/17 17:05
|
|||
|
||||
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.
