:::
Browsing this Thread:
1 Anonymous Users
|
Re: 關於banksel
|
||||
|---|---|---|---|---|
|
版主
 
|
看它不高興可以觀掉它。
MPLAB IDE --> Build Options --> Project --> MPASM Assembler --> Output --> 變更 Diagnostics Level 就搞定了
發表於: 2006/4/27 15:39
|
|||
|
||||
|
Re: 關於banksel
|
||||
|---|---|---|---|---|
|
版主
|
只是提醒而已，可以不理它。
發表於: 2006/4/26 20:28
|
|||
|
||||
|
關於banksel
|
||||
|---|---|---|---|---|
|
初級會員
 
|
list p=16F877
#include<p16f877.inc> trans_c equ 0x20 org 0x00 nop initial: movlw .10 movwf trans_c banksel SPBRG movlw .36 movwf SPBRG ^^^^^^^^^^^^^ bcf TXSTA,SYNC ^^^^^^^^^^^^^^^^^^^^^^^^^^ bsf TXSTA,TXEN ^^^^^^^^^^^^^^^^^^^^^^^^^^^ banksel RCSTA BSF RCSTA,SPEN Trans: banksel TXSTA ^^^^^^^^^^^^^ btfss TXSTA,TRMT goto Trans banksel TXREG movlw 0x55 movwf TXREG banksel trans_c decfsz trans_c,f goto Trans end 這是個pic連續傳送出10個0x55的8位元資料 由RS232輸出 雖然BUILD SUCCEEDED 但上面程式有箭頭的部份 出現下面ㄧ些message Register in operand not in bank 0. Ensure that bank bits are correct. 是哪邊問題 我有切bank阿.... 為什麼???會出現上面訊息 謝謝您的回答
發表於: 2006/4/26 17:22
|
|||
|
||||
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.
