你好!!
目前以pic18f45j10為核心,使用enc28j60 ethernet controller,發展ethernet interface....
也下載了TCP/IP Stack 3.20....
我要如何在眾多的副程式下去設定PHY,MAC達到訊號發送,以及符合DHCP!!
也花了1天的時間看了TCP/IP Stack的.H及.C 檔案,
之前也獨自嘗試過撰寫enc28j60 spi 驅動程式,這都讓我嘗到苦頭,上了5/19產品研討會後才知道可以直接運用libray及修正開發方向,這讓我感到開心,是否可指點小弟再開發的過程中能順利一些.....
謝謝.......