:::
Browsing this Thread:
1 Anonymous Users
|
Re: 请教：用MCD2烧录dsPIC30F5015，出现的问题。
|
||||
|---|---|---|---|---|
|
新會員
 
|
注意连线一定要对，
發表於: 2007/11/15 22:50
|
|||
|
愿我们大家一起努力,把PIC单片机学习网打造成全国最大的单片机交流平台. http://www.pic16.com
|
||||
|
||||
|
Re: 请教：用MCD2烧录dsPIC30F5015，出现的问题。
|
||||
|---|---|---|---|---|
|
版主
 
|
再第一個位址就錯了(0x0000) , 所有的電源腳都有拉嗎?
也有可能是元件壞了?
發表於: 2007/11/9 18:16
|
|||
|
||||
|
请教：用MCD2烧录dsPIC30F5015，出现的问题。
|
||||
|---|---|---|---|---|
|
新會員
|
用ICD2烧录dsPIC30F5015
问题： 烧录时有时正确，但有时出现下面的错误提示，能够烧录成功的次数极少。 MPLAB ICD 2 Ready Erasing Target Device... ...Erase Succeeded MPLAB ICD 2 Ready Blank Checking... .. Config Memory ...EEPROM ...User ID Memory ...Blank Check Passed MPLAB ICD 2 Ready Programming Target... ...Validating configuration fields ...Erasing Part ...Programming Programming Executive ...Verifying Programming Executive ...Programming Program Memory (0x0 - 0x29FF) Verifying... ...Program Memory ICD0161: Verify failed (MemType = Program, Address = 0x0, Expected Val = 0x40100, Val Read = 0xFFFFFF) ICD0275: Programming failed. 为什么总出现这个提示呢？ 硬件中5根线MCLR，VDD，VSS，PGC，PGD分别从单片机直接引到水晶头上的，只有MCLR接了一个10K的上拉，其他的什么也没接。 IDE用的是MPLAB7.6
發表於: 2007/11/8 14:37
|
|||
|
||||
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.
