Re: debug problem (not sure)
|
||||
---|---|---|---|---|
資深會員
|
configuation should can select in development tools.
if your OSC is XT(code),you should set XT in development tools. when all setting are same,the programming will be ok. but,no errors need your CODE 原來 你在1月15號的時候 已經發問過了,而且還是打簡體字 簡單的來說 開發工具的設定值 要符合程式內的設定值 你的問題出在開發工具的設定值,與程式內定值不一樣 所以請你好好看一下開發工具內的HELP 因該會有設定configuation的相關說明 照理說你們那邊的資原因該比台灣豐富才是,怎麼跑過來問了 問也沒關係,相關名稱用原文就好,用大陸用語,反而讓人看不懂
發表於: 2010/1/29 15:47
Edited by foxjan on 2010年01月29日 17:38:12
Edited by foxjan on 2010年01月29日 17:39:03 |
|||
My name is jan,Jan是棒的
|
||||
|
Re: debug problem (not sure)
|
||||
---|---|---|---|---|
新會員
|
Thanks man for ur replying..
I used the words as below.. #include"18f46k20.h" #fuses XT,NOWDT,NOPROTECT,PUT,BROWNOUT,NOLVP #use delay(CLOCK=32768) but it seems not match as I run the debugging mode.. Not sure. Could u give me an example in detail..
發表於: 2010/1/29 14:26
|
|||
|
Re: debug problem (not sure)
|
||||
---|---|---|---|---|
資深會員
|
configuation 需要跟MCU上的設定一樣
configuation need fllow MCU(CODE)
發表於: 2010/1/28 9:18
|
|||
My name is jan,Jan是棒的
|
||||
|
debug problem (not sure)
|
||||
---|---|---|---|---|
新會員
|
Since I have a set of microchip pic18f46k20 start kit board,I just want to program it and debug it..
I used the ccsc pcwhd,and a ICD-U40 for programming.When I debugging it,it always says "configuation fuses "were wrong.. I just guess maybe its based on C18,not ccsc.. thank anybody help me.. Attach file: (0.00 KB)
發表於: 2010/1/28 9:10
|
|||
|